How to get EP3.0 or EP3.2 Admin-Tool to work
1.) After downloading Derivative-AdminTool (Click here for thread) open the file using PE Explorer and Save it, without doing anything.
2.) Open the saved file using a Hex-Editor.
3.) Go to Position "FF810". There you find your XOR-Code!
4.) Now copy all Chars until you reach '.Saturday'
5.) Start your Adminclient (without exiting your Hex-Editor) and click on "SC Encrytion".
6.) In the first field enter your IP, username and last your password using the key you found in step 4 in the second input.
7.) Now go to Position "FB13C".
8.) The result you get you have to enter in Hex-Editor now.
9.) Enter your XORed IP-Adress on this position overwriting the value before. If your XORed Ip-Adress should be smaller than the value before you have to set this left chars to "00".
10.) After some points you see the next value, this is the IP-Adress again. Enter the same way you did before.
11.) There is a little "break" between the rows of points and this two chars are your Port. Now open Calc and type in your Port, convert it to hex and if you would get: AB12, you have to put 12AB in Hex instead of this two chars.
12.) Here you have to enter your XORed Username of Database.
13.) Some points later - again - you have to enter the XORed Password.
14.) Save & Enjoy.
I hope my English isn't too bad and you understand what I mean :)
If there is something thats too hard to unterstand, just post here.
Renaissance
Ragezone